|
||
|
 |
|
||||||||||||||||||
|
#1
28-01-2010
|
||||
|
||||
Toe in / out guages
I've been really bad recently at setting my toe in / out. Are there any decent guages out there that help etc.
Particuarly for the Cat SX / B4 
|
|
#2
28-01-2010
|
|||
|
|||
|
I use a M Racing setup station when I am setting up.Track side I use a AE B4 and a PBM camber gauge. On a B4 you can see the toe in/out by looking at the outer hinge pin which is straight and the angle of the front wheels.
__________________
Schumacher KC, KD, CAT XLS, CAT L1 | Team C TM2 V2, TM4, TC02 | JQ The Car | Mugen MBX6 | Losi 8T,8BE 1.5 | Durango DEX-410V4 | FTX Blaze | XRAY M18T | Kyosho STR,Surf Dude,Nexus 30 | Nimrif Makara | MFA Spear | She Devil | T-Rex 450SEV2,250SE | Ark X-400 | Protech Butterfly,Zoom 400 | Ikarus Piccolo | VW T4 | Smart 450 | KC-250 | BoltRC Kraken 5" | Emax Nighthawk 250 | Gravity 250 | S550 | Prusa i3 | TronXY X5A | Must stop collecting stuff!
|
|
#3
28-01-2010
|
||||
|
||||
|
Got a M-Racing one, but haven't found it that accurate. Did the camber on it and then checked it with a RPM camber gauge. Let's just say I didn't trust it afterwards..
I've got a schumacher camber gauge and access to a good RPM one
|
|
#4
28-01-2010
|
|||
|
|||
|
One problem when trying to set-up accurately is the amount of movement in the ball cups and the bearings. Sometimes it can also look different when you change the tyres. Also a very good flat surface is required as well.
__________________
Schumacher KC, KD, CAT XLS, CAT L1 | Team C TM2 V2, TM4, TC02 | JQ The Car | Mugen MBX6 | Losi 8T,8BE 1.5 | Durango DEX-410V4 | FTX Blaze | XRAY M18T | Kyosho STR,Surf Dude,Nexus 30 | Nimrif Makara | MFA Spear | She Devil | T-Rex 450SEV2,250SE | Ark X-400 | Protech Butterfly,Zoom 400 | Ikarus Piccolo | VW T4 | Smart 450 | KC-250 | BoltRC Kraken 5" | Emax Nighthawk 250 | Gravity 250 | S550 | Prusa i3 | TronXY X5A | Must stop collecting stuff!
|
|
#5
28-01-2010
|
||||
|
||||
|
I shall give it all another go.
Can't get much flatter than the kitchen surface (just got to dodge the Mrs)
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
