Tekin rs pro wont work

[Rebelrc]

Hello can anyone help me please?
I have just purchased a Tekin rs pro and spent all night wiring it up beautifully
I Then came to switch it on and set it to the hand set....it wont set the brakes or recognise me pulling the stick back to the brake position??? and wont end the set up sequence....any ideas please

[DCM]

first try the servo reverse, and also check your EPA for throttle AND brake are set to 100%, get back with what happens.

[Rebelrc]

Hello DCM thanks for the help but whats an epa?

[hide]

What radio do you have?

[Rebelrc]

Vantage 2 KO
does anyone know the settings for it
or shall i just factory reset it and try again?

[DCM]

make sure your end points are at 100 for your brake and throttle, try again, if no joy, try servo reverse on the throttle.

[Rebelrc]

The only way i can get it to work is to reverse the servo on the throttle Will this bugger it up? is this ok? do Tekin need to send me another speedo?

[DCM]

I can't remember with the KO, but if it wont set with the EPA set to 100%, then you need to flip the servo reverse, like you would if you steering was going the wrong way.

[HarlowS]

I have had the same issue with my KO. If you simply reverse the throttle on the transmitter and set it like that, then switch it back again all will be fine.

[Rebelrc]

I think ive sorted it now with servo reverse ( is this ok?)
many thanks
thought i was going madder....
just had a go at checking all the brakes etc and the way it works with all the lights and beeps reminds me of my all time favorite speedo the MRT Vtrac they were ace!

[Rebelrc]

Cheers Harlow
many thanks
when you say switch it back what did you mean ?

[HarlowS]

set it with your throttle reveresed on your tx, when its calibrated ok just change your tx back to how it was.

[Rebelrc]

Sorry mate am i being a numb nut .
do you mean set the speedo up with the throttle servo reversed then once it is set set the throttle to normal ...wont the car go backwards
thanks for the help HarlowS, sorry i am struggling with this...

[DCM]

you should just reverse it and leave it, as if you swap it back after, it won't work.

Is your KO one with the model memory?

[Rebelrc]

I think so its a type R

[DCM]

so you set it in the menu's then

[Rebelrc]

Set what in the menu's?
sorry i am being thick DCM

[HarlowS]

In the menu on your KO the throttle will be set to normal ?? yes ? change it to reverse then set your speedo up as normal using the quick setup. When it has calibrated your forward and reverse positions change the tx back to 'normal' on the throttle. Job done. Dont know what causes it but that has worked fine for me in the past.

[Rebelrc]

thanks stuart i have tried this but it just goes backwards

[HarlowS]

what if you change your throttle back to reverse on your tx ??