|
#1
|
||||
|
||||
![]()
With universal-shaft driven cars like the BJ4, S4 and Aero - how big is this problem? Does it bother you while driving? Will it pull to one side when accelerating? Twist when jumping etc? (motor will act as a gyroscope)
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
#2
|
|||
|
|||
![]()
this was my biggest fear when switching to a shaft car.
but its not noticeable, I think the 4 off-road wheel we have spinning far out-weigh the motor/shaft gyro/torque effect. I think a lot of the TC boys are feeling it, thats why shaft is being phased out in 10th TC, but they only have tiny light wheels. |
#3
|
|||
|
|||
![]()
It can make the car roll very slightly in the air as you get on and off the throttle, but with a bit of practice this can be countered with steering although usually you don't have to bother (at least with the BJ4WE)
![]() On the track I don't notice any torque effect with my BJ4, I imagine the Aero wil be no different ![]() |
#4
|
||||
|
||||
![]()
Thx guys! Just what I thought (and hoped :-)
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
#5
|
||||
|
||||
![]()
Yep. Those 4 wheels are bigger, heavier gyros than the motor. besides, the motor has got a nice counter-balance axle. (spur, shaft)
|
#6
|
|||
|
|||
![]()
Just to agree with whats already been said, the only time I did notice it with my S4 was being over ambitous with the throttle in the air, and even then it wasn't as bad as when I did a winter of racing a TC3 on carpet!!
__________________
Norfolk Buggy Club- Norfolk's 1/10th and 1/8th Premier Off Road Model Car Club in association with BRCA East of England 1/10 Off Road Regional Racing JemmettFox- Accountants and Business Advisors Click any of the above to head to the website! |
#7
|
||||
|
||||
![]() ![]() Used to run rubber bands in TC's but had one snap adn it is was a pig to replace in time, never had a shaft break yet! ![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|