|
||
|
 |
|
||||||||||||||||||
|
#1
30-09-2009
|
||||
|
||||
Electronics
Few bits that are surplus to requirements.
GM 120 esc Fitted with the latest 7.2 firmware (silly fast in stock classes) Will come with fresh full length wires, Couple of GM sensor cables, PC USB cable, Perfect working order, boxed with instructions Only used for Vegas IIC race £175 Inc special delivery KO 2413 low profile servo Recently re-cased, had half of one of the mounts cut off, Shorten'd wire, Perfect working order. £45 Inc special delivery MRT PTX One of those 20 number jobbies, Again only used at Vegas IIC race Perfect condition, includes manual booklet £35 Inc special delivery GM 6t delta wind motor Little use, Perfect working order, £25 Inc special Delivery GM 120 esc This one runs on firmware 4.9 (std) **this esc was modified to run in 12th cars** case taken off cut down for weight, Capacitor board cut off and mounted separate Case is now polycarbonate, * neat job * Includes couple of sensor wires Pc USB cable Not sure how this will perform in TC now with regards to heat. £100 Inc special delivery Looking for a good spec mountain bike to trade Pm or email me, [email protected] Luke Last edited by lukehobson; 30-09-2009 at 02:08 AM. Reason: Wrong servo number.... C'mon it was early! |
|
#2
30-09-2009
|
||||
|
||||
|
ptx sold, thanks :-)
|
|
#3
30-09-2009
|
||||
|
||||
|
Bump, anyone? ONO on all items
|
|
#4
03-10-2009
|
||||
|
||||
|
Both GM esc's sold pending payment,
Still have the GM 6t delta motor and KO servo left Luke |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
