|
||
|
 |
|
||||||||||||||||||
|
#1
06-07-2009
|
||||
|
||||
7/64" drill bits
The exact right size to 'clean out' the pivot pin holes on a B4. Use these to put right the new moulded parts (30 degree caster blocks) that are, shall we say, a little tight!
Can also be used to clean dirt out of used parts during a rebuild on used parts - just turn the drill in the wishbone by hand. £2 posted - Paypal Gift payment. G
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing 
|
|
#2
06-07-2009
|
||||
|
||||
|
add one to my self of ever growing bits maximum BOSS
|
|
#3
06-07-2009
|
||||
|
||||
|
Hey,
Clear your PMs. MiCk B. :-)
__________________
http://www.dublinmodelracing.com/ (Off-road racing in Dublin) http://www.p-dubracing.co.uk (Stocking: 8Racing / AVID / GHEA / Xpert Racing / Factory R/C / Alton Design Innovations) http://www.msdmodels.ie/ (Trackside and on-line RC supplies.) |
|
#4
06-07-2009
|
||||
|
||||
|
Sorry
 Done
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing
|
|
#5
09-07-2009
|
||||
|
||||
|
PM sent
MiCk B. :-)
__________________
http://www.dublinmodelracing.com/ (Off-road racing in Dublin) http://www.p-dubracing.co.uk (Stocking: 8Racing / AVID / GHEA / Xpert Racing / Factory R/C / Alton Design Innovations) http://www.msdmodels.ie/ (Trackside and on-line RC supplies.) |
|
#6
03-08-2009
|
||||
|
||||
|
Still got some left
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing
|
|
#7
24-09-2009
|
||||
|
||||
|
Still got some.
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
