|
#1
|
||||
|
||||
![]()
does any-1 know how to setup an x-6 so it has an assgressive feel to it.
![]() ![]() ![]()
__________________
EAT, SLEEP & RACE. Keeping fast motors reving hard. signed...migsy racing made better by Losi, Team Xtreme, HPI BAJA 5B. novak, castle creations, trak-power lipos bantam B6 and my SMR nicely done by huski sport uk. ![]() www.the-pred.co.uk RC BEARINGS 4 U. Club 22 (admin) Losi22, losi xxx cr losi xx-4, losi xxx-4G baja 5b 30.5cc. |
#2
|
||||
|
||||
![]()
what are you running now, ie pistons shock springs oils etc and on what surface,
__________________
Mattys the driver,my names carl
|
#3
|
||||
|
||||
![]()
how aggresive do ya wnat to be
![]() |
#4
|
||||
|
||||
![]()
losi shocks, orange pistons, 35wt all round. blues at front, reds on rear.
it seem to get alot of under-steer. ![]() ![]() ![]() ![]()
__________________
EAT, SLEEP & RACE. Keeping fast motors reving hard. signed...migsy racing made better by Losi, Team Xtreme, HPI BAJA 5B. novak, castle creations, trak-power lipos bantam B6 and my SMR nicely done by huski sport uk. ![]() www.the-pred.co.uk RC BEARINGS 4 U. Club 22 (admin) Losi22, losi xxx cr losi xx-4, losi xxx-4G baja 5b 30.5cc. |
#5
|
||||
|
||||
![]()
how much can i get out of a good setup?
![]() ![]() ![]() ![]()
__________________
EAT, SLEEP & RACE. Keeping fast motors reving hard. signed...migsy racing made better by Losi, Team Xtreme, HPI BAJA 5B. novak, castle creations, trak-power lipos bantam B6 and my SMR nicely done by huski sport uk. ![]() www.the-pred.co.uk RC BEARINGS 4 U. Club 22 (admin) Losi22, losi xxx cr losi xx-4, losi xxx-4G baja 5b 30.5cc. |
#6
|
||||
|
||||
![]()
firstly make sure your diff isnt to tight,then run a softer spring up front,make sure weight distribution is around 65% rear 35% front,also what anti squat are you running, and were in the corner is it understeering,
__________________
Mattys the driver,my names carl
|
#7
|
||||
|
||||
![]()
More weight, move shocks out 1 hole on rear tower, lower front axle height, e-speed hangers, 30 degree castor blocks, inline axles, move rear shocks out one hole on rear wishbone, 3 degere rear toe in.
One or more of these may help, unless you fill in a setup sheet for us to see it is almost impossible to give a definative answer. |
#8
|
||||
|
||||
![]()
cheers for all the response guys. i've gone and put orange losi springs on front, pinks on the rear. i am now working on the camber and toe-in.
would any-1 know where i could run off a few setup sheets? cheers..ALAN
__________________
EAT, SLEEP & RACE. Keeping fast motors reving hard. signed...migsy racing made better by Losi, Team Xtreme, HPI BAJA 5B. novak, castle creations, trak-power lipos bantam B6 and my SMR nicely done by huski sport uk. ![]() www.the-pred.co.uk RC BEARINGS 4 U. Club 22 (admin) Losi22, losi xxx cr losi xx-4, losi xxx-4G baja 5b 30.5cc. |
#9
|
||||
|
||||
![]()
I WOULD SAY GOING INTO A CORNER WOULD BE ABOUT RIGHT.
__________________
EAT, SLEEP & RACE. Keeping fast motors reving hard. signed...migsy racing made better by Losi, Team Xtreme, HPI BAJA 5B. novak, castle creations, trak-power lipos bantam B6 and my SMR nicely done by huski sport uk. ![]() www.the-pred.co.uk RC BEARINGS 4 U. Club 22 (admin) Losi22, losi xxx cr losi xx-4, losi xxx-4G baja 5b 30.5cc. |
#10
|
||||
|
||||
![]() |
#11
|
||||
|
||||
![]()
Did you add weight yet Migsy? I know we keep banging on about it, but it really does work. I wouldn't have it at first, but now I am 100% convinced it is the way to get an X-6 to perform.
|
#12
|
||||
|
||||
![]()
YES MATE, I GOT A FEW IN THERE. IF I CAN REMEMBER RIGHT, I THINK ELLIS WAS SAYIN TO ADD 120 IN THERE1!!!!
__________________
EAT, SLEEP & RACE. Keeping fast motors reving hard. signed...migsy racing made better by Losi, Team Xtreme, HPI BAJA 5B. novak, castle creations, trak-power lipos bantam B6 and my SMR nicely done by huski sport uk. ![]() www.the-pred.co.uk RC BEARINGS 4 U. Club 22 (admin) Losi22, losi xxx cr losi xx-4, losi xxx-4G baja 5b 30.5cc. |
#13
|
||||
|
||||
![]()
Yup! 120g, all in front of the Lipo
|
![]() |
Thread Tools | |
Display Modes | |
|
|