looking for a straight swap.

[rowanp25]

right i have a tenth tech predator P8 including ball raced rockers n steering. theres a good lot of spares including spare chassis with cell slots cut out spare bearings for the entire transmission, a tub of diff balls and same amount of thrust race balls and washers ect, roughly 4 pairs of complete diffs as well as 3 complete modded Tc3 diffs and 2 tc3 pinions (only needs the addapters) theres 4 pairs of crown gears and about 6 pinions. theres also lots of drive shafts, hubs, and wishbones plus a spare front top diff housing. also included would be a nosram dominator evo speedo, standard hotwired accoms servo, 2 or 3 motors (various makes and all 10x2) a pack of Gp 3300s, an lrp diamond tipped comm lathe and anything else iv forgotten! pic of pred in profile.

what id like is a similar setup but in 1/8th nitro rally x with starter, engine, pipe, throttle servo, maybe some spares n whatever else you wanna chuck in!
cheers
\Ro

[scotoap]

ggivimg up EP then?

[rowanp25]

not sure it depends whats offered really

[rowanp25]

change of plan! my new main club will be electric n runs in falkirk! i was gonna give it a go over at csor but your alegedly not allowed to have an opinion over there or stick up for yoursely shame theyll have "the best track in scotland" but itll be run by monkeys