|
#1
|
|||
|
|||
![]()
Hi all, I'm working on my first restoration project (Lazer ZX) and the turnbuckles and dogbones have some surface rust. Is there a method I can use to get them looking new again?
Many thanks in advance, Jay. |
#2
|
||||
|
||||
![]()
I always run them up in a drill with some metal polish
__________________
My feedback feel free to add anything ![]() http://www.oople.com/forums/showthre...863#post861863 |
#3
|
||||
|
||||
![]()
Or you could buy lunsford tie rods & stainless steel screws
__________________
www.kamtec.co.uk www.fibre-lyte.co.uk answer-rc.com/uk/en/ Answer UK team driver Designer of the Lazer ZX/ZXR carbon fibre tub chassis Designer of the Lazer ZXRS |
#4
|
||||
|
||||
![]()
Stick them in some phosphoric acid solution or if you don't have that, overnight in some Coca Cola.
|
#5
|
||||
|
||||
![]()
or if they are very rusty use electrolysis, works very well
|
#6
|
||||
|
||||
![]()
If you get the worst off with a fine steel wire cup brush in a drill then swap to a brass wire brush it adds a slight gold sheen
|
#7
|
|||
|
|||
![]()
Thanks for the replies everyone, loads to go on there.
|
#8
|
|||
|
|||
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|