Orca Vritra VXX

[Hydrakermit7]

Hi all,

Sorry I didn't really know where to post this, so id thought id post it here.

I've been getting a problem with my speed controller I believe it to be the problem.

What happens is; when I use my transmitter to accelerate, the motor sometimes starts turn and other times it doesn't.

Now I thought it might of been the receiver, so I brought a new one and I'm still getting the problem.

Then I thought it may of been the motor, so I had it apart to check for damage or a build up of crap.

The motor seems fine as well, I even soldered a different older motor with the speedo and it worked at first, then I switched it off and It wouldn't even accelerate.

I've even changed the sensor wire as I though it was that.

Any ideas of what it could be? Or anybody has a similar issue before?

The Speedo controller and motor are both less than 3 months old, and im just getting no drive from my motor.

I'm getting very frustrated so if anyone could help that would be great.

Thanks in advance.

[AfroP]

sounds like it could be an issue with the sensor in the speedo
i had a similar issue with an lrp speedo

sent it back in warranty and it was swapped out

I'd suggest you do the same

[Hydrakermit7]

Thanks for replying to my post, I have sorted it now, what happened is I forgot to waterproof the Motor sensor part and went slightly through a puddle. I took the motor apart and cleaned the water residue that was left on the motor sensor unit. after that all worked fine

Thanks,