HW v2.1 boost settings (not available)

[Gunthar Guntharsën]

Hi, on my 2.1., the settings "boost start rpm" and "boost timing acc" are visible (in a lighter color) but blocked. The boost timing is available.

The firmware I'm using is:

esc: v3.0 110930 MOD
program box: v1.08 120504

What can I do to make these settings available? I would like the car to be calmer in the infield and I think this could help me a lot.

Thanks

[Hog]

I'd hazard a guess that it's because you're trying to put V3 settings on a V2.1 box?

Also it might be worth trying the STK firmware rather than MOD?

[Getpip]

Mod software is restricted to stop you blowing everything up.
If you want the extra settings you need to install 930Stock.

[Gunthar Guntharsën]

Thanks Pip I have them now. Any good starting setups would be welcome. I'm running a 7.5 in 2wd off road.

[Gunthar Guntharsën]

Ok, just a little report after testing with the stock software (might be of use to somebody, you never know).

I ended up with the following settings (7.5 turn hpi motor, timing on the can set at minimum):

boost timing 26°
boost start rpm 9000
boost acc 750
turbo boost timing 0°

The car was much easier to drive consistently. It's a lot calmer on the throttle and very fast on the straight. I made much less mistakes than before and it was easier to push the car hard. The car was bloody good today.

Temps after a 10 minute run were 45°c (esc) and 65°c (motor).