Center Diff Mount/Upper Plate/Motor Mount problem

[kyfran95220]

Hi guys,

Here is my problem, I've bought these option parts and tried to mount them.
But once done, the slipper is just moving as if the ball bearing were not stucked.

I run with the Slipper with Durango spur + pads.
Could it be the main problem ?

Do i Have to shim something ?

Thx in advance

Franck

[john333]

I had this problem on my 4wd car. I fixed it by glueing a little thin plastic on the bearing face of the bolt on top piece (the bit that clamps the slipper bearings in place)

It seems a few parts were made wrong a while back.

[kyfran95220]

Hi John and thank you for your answer.

Do you think it could be possible to show me your tip with a picture ????

I have to glue this thin plastic part on both side of the "cover" ?




What do you think about glueing these places with thick double tape ?
That could clamp & glue the bearing ?

[john333]

yes, where you have marked your diagram with the red arrows is where i glued some material. I used some lexan from a bodyshell and then sanded it down until it was the perfect size.

I think double sided tape would be too soft.

Yes, on both sides of the bearing surface of the plastic.

[kyfran95220]

Thank you very much John

I thought I have made a mistake with this order

[john333]

No problem

[kyfran95220]

FYI, it works great !!!!

[john333]

good news, I never had another problem when I'd done it