|
#1
|
||||
|
||||
![]()
Hi All,
I have now installed a new speed passion motor 7.5T into my 2wd buggy (I am running a SP GT2 Pro ESC as well). All works fine but the motor itself is emitting a beeping sound. It is not on a regular cycle/repeat. The car also twitches ever so slightly forward occasionally when in neutral. I did not have this issue with the previous motor (a SP 13.5T). I have re calibrated the throttle settings but wondered if anyone else had experienced this and if its a setting on the ESC? I have taken off the timing programme and all other settings are pretty standard. I tend to think its a throttle issue but the only thing I have changed is the motor? Like I say it runs but am sure beeping and slight twitching is not normal ![]() |
#2
|
||||
|
||||
![]()
that would mean your in set up mode im guessing
__________________
Mattys the driver,my names carl
|
#3
|
||||
|
||||
![]()
If not in setup mode, sounds like your radio is not really at neutral or there is some interference.
|
#4
|
||||
|
||||
![]()
Thanks Guys, all sorted hopefully. When I first had the car the set up/car went back instead of forwards when I pressed the stick controller forward. I therefore changed the transmitter setting to Rev to overcome.
I have since got a new ESC and motor. I set the throttle parameters but was getting twitching when in neutral. After a few investigative trials I changed the transmitter back to normal and reset all to factory settings and made sure that the Tx was now not as rev to trial. I then calibrated the throttle again and all appears to be fine now. Bit strange but think it's sorted. |
![]() |
Thread Tools | |
Display Modes | |
|
|