|
#1
|
||||
|
||||
![]()
im in the middle of building the diff. followed the usual instructions etc but i find the diff halves are slopping side to side a little , the diff screw is tight, got the correct shim in it etc and ive took it apart and re-checked everything but still the same.?
__________________
2002, 3 , 4 B.R.C.A Scottish indoor TC champion. 2005......... B.R.C.A Open modified Scottish TC champion. 2011....... Scottish Indoor OFF-ROAD champion. 2012 ......... Scottish SORC Off-Road Runner up. 2022.....x2 scottish sorc sors vetern champion My oOple Trader feedback http://www.oople.com/forums/showthread.php?t=84630 |
#2
|
|||
|
|||
![]() Quote:
The internal diameter of the two thrust race washers are different - one is slightly smaller. You can see this with your eye - you don't need a calipers. Make sure the smaller ID washer is closest to the diff bolt head.
__________________
www.facebook.com/racewayone RACEWAYONE :: LMR :: MIBOSPORT :: RC CONCEPT :: SMD Trader Feedback: http://oople.com/forums/showthread.php?t=81070 |
#3
|
|||
|
|||
![]()
make sure and watch the diff build video on the Durango website
it explains a whole hell of a lot more than the rubbish manual |
#4
|
||||
|
||||
![]() Quote:
will do mate, and cheers.
__________________
2002, 3 , 4 B.R.C.A Scottish indoor TC champion. 2005......... B.R.C.A Open modified Scottish TC champion. 2011....... Scottish Indoor OFF-ROAD champion. 2012 ......... Scottish SORC Off-Road Runner up. 2022.....x2 scottish sorc sors vetern champion My oOple Trader feedback http://www.oople.com/forums/showthread.php?t=84630 |
![]() |
Thread Tools | |
Display Modes | |
|
|