Don't know where I am going wrong but can't get my charger to store and then load different battery charge settings.
What I am doing is select Save Data, [01] flashes then set the values of the battery then when finished hold down the Enter button until it bleeps then press Type button until [01] flashes, press inc button to select [02], put in settings for second battery then press and hold Enter until bleeps again and so on.
When I then go to Load data and select [01] or [02] etc the settings that I put in are not correct.
Eg [01] set for Lipo 3.7v (1S) at 3200mAh (Core Lipo)
Select Load Data [01] and now it comes up with Lipo 5.0A 7.4v (2S)
Hope that makes sense.
I must be doing something wrong as I am having the same problem with another charger, which obviously uses the same software, so it is not the charger which was my first thought.
Been trying to sort it for well over an hour now and it is starting to really annoy me now because I know that I have done it before but can't now remember how.