|
#1
|
|||
|
|||
![]()
Hey guys
Was hoping to sort this problem out as I am having this issue with my sanwa exzes plus binding with my 2 receiver which is 451 & 451r Problem started yesterday at seaham which my buggy ran fine almost 5 min then decided to stop working so Marshall brought car over to me to rostrum but all is fine ! Till car went out more than 20 feet it cut off again ! I presumed esc overheat but it was warm. but it wasn't that it turn out the receiver 451r not bind with my exzes tranny so I tried bind it fair few time but no luck even fellow racer tried ! So I managed to get another receiver off my other buggy to use so all fine till I went next heat till almost 5 min it gone off again lost of connection so that 2 receiver not bind with my tranny even try bind it again ! it work ok but more than 20 feet it cut off ! On my xray xb4 Esc is speed passion 2.0 pro with 6.5 sp, savox servo 1251 So did u any chance experience this problem and solved it ??? I purchased the sanwa exzes from mb models a month ago |
#2
|
||||
|
||||
![]()
It's the rx as mine went as well, mine cut out after 15 feet. I had to send it back to smd and it was replaced.
__________________
Xray, Orca, 1UP Racing, Avid, X Factory UK, RC Disco, Hudy, RichPaint, RDT products, Screwz4rc http://www.screwz4rc.co.uk My Trader Feedback - http://www.oople.com/forums/showthre...hlight=tyreman
|
#3
|
|||
|
|||
![]() Quote:
My 2 rx was working fine till one went then other went same night ![]() |
#4
|
||||
|
||||
![]()
Matty's did the same thing it was the aerial on the transmitter, theres a wire inside that gets caught and then snaps,
__________________
Mattys the driver,my names carl
|
![]() |
Thread Tools | |
Display Modes | |
|
|