Wheel fitting

[K-Brewer]

Have just become a proud father of a Dex210 an was wondering if anyone know how to convert/fit associated 2wds wheels on the front? I know the bearing sizes are different but wondered if there were any other bearings i could use instead of buying all new wheels again

Thanks for looking guys

[jo90]

I believe you want these -

http://www.tresrey.com/tresrey/produ...td074_eng.html

They are the Tresrey front axle's to fit B4 wheels

[jo90]

PS Part number is TYTD074

[MiCk B.]

These should also be available:

Revolution Design Racing Products
RDRP0055 Imperial titanium front wheels axles (DEX210)

Supplied by DMS in the UK.

MiCk B. :-)

[K-Brewer]

Originally Posted by MiCk B.

These should also be available:

Revolution Design Racing Products
RDRP0055 Imperial titanium front wheels axles (DEX210)

Supplied by DMS in the UK.

MiCk B. :-)

Cheers guys, can't seem to find the part on DMS's website

[jo90]

MB Models have the Durango Imperial stubs also

http://www.rccarshop.co.uk/index.php...axle-pair.html

[K-Brewer]

Sorted now, thanks guys saved me a few £'s

[RichieZXR]

Hey there, are there any other hex adaptors for the 410 ? I have loads of sets of hpi five spoke wheels which are the old kyosho fitting... They are light wheels so was wondering if they could be fitted to my 410 ? Plus they look bling (the real reason for wanting to fit them)

Cheers

Richie

[JohnM]

Originally Posted by RichieZXR

Hey there, are there any other hex adaptors for the 410 ? I have loads of sets of hpi five spoke wheels which are the old kyosho fitting... They are light wheels so was wondering if they could be fitted to my 410 ? Plus they look bling (the real reason for wanting to fit them)

Cheers

Richie

I'm sure you could fit some different hexes on if you wanted, I think a mate was using some of his old Hot Bodies wheels a few weeks back.

[jo90]

Yep, I believe the HP/HPI hexes will fit the rear of the car. You will need to tailor though the pin that goes through the stub axle as I believe the pin used on the DEX210 is thinner than that of the HP/HBI stub axles.