Mad rat stainless screw set

[Bluestreak]

Will this give all screws for the mad monkey!! found one on flea bay.

http://www.ebay.co.uk/itm/RPC-Racing...item4ab2bfbb6e

[Hpi_guy]

probably would work but fancy screws arent worth it as they fall out, fall of tables, get lost, break, wear out, just buy a bag of cheap standard ones, thats my opinion anyway

[Bluestreak]

ok. I was just considering them as alot of people seemed to think that the ansmann screws are a bit soft!!??

[Hpi_guy]

i built my first ansmann kit at Christmas and used a proper set of aleen drivers and not one screw was soft or rounded off, its all down to the tools that are used

[Crazy L]

I recently built a Monkey, using my trusty Hudy drivers. I found the standard screws to be utter tripe, with decent tools too.

[metalmickey0]

I recently changed all the screws on my monkey with stainless ones. I got all mine from rcmodelfixings.co.uk Dead cheap to so got loads of them just to make free postage.

[Mad-Wolfie]

The reason the kit screws round off is because they are not a true 2mm allen head, but nearer a 5/64 imperial & most people use a 2mm driver which does round the heads.

You can use a 2mm but if they round off, use a 5/64 driver.

[VintageRacer]

I've used Spalding Fasteners before. Ended up spending about the same as most people were selling screw sets for but had loads of spares.