Less anti squat on tc02c

[john333]

Never been a fan of anti squat on my cars so on the tc02c I've removed some material from the inner camber link bracket to allow the toe in block to be raised using washers. This makes the pivot pin level.

Attachment 44816

[ben44]

Nice, but i used the alu part you dremel ...
I'm not sur to do the same, mabby i will try on the original one first.

[madmax]

it is a simple conversion, i did it last year the main advantage is more grip on low grip serfaces

[john333]

Originally Posted by madmax

it is a simple conversion, i did it last year the main advantage is more grip on low grip serfaces

That's why I've done it, this weekend is Worksop which is very low grip

[john333]

Originally Posted by ben44

Nice, but i used the alu part you dremel ...
I'm not sur to do the same, mabby i will try on the original one first.

Yes, try the plastic one first by dremelling, then if you like it get the ally one machined. You may not like how it feels

[Robbiejuk]

Whats the screw in the middle for?

[ben44]

Who many Mm did you putt on your car.

[john333]

Originally Posted by Robbiejuk

Whats the screw in the middle for?

Lol, have been fettling up a roll bar for the rear, that is one of the screws that hold it in place

[john333]

Originally Posted by ben44

Who many Mm did you putt on your car.

2mm on my car. I could have removed more plastic to allow 3-4 mm but didn't want to weaken it

[madmax]

I will be at southport this weekend at the turf wars meeting.

if you would like to have a look at my car you are welcome to.

and you can see what mods i have done.

[mr emily]

How many degres of anti squat does the tco2c have as standard?

keith