CAT SX3, change Servo and speedo

[juergen_jl]

Hi,

I'm not very happy with the wiring in my SX3. The speedo on the left and the motor on the right side cause long wiring above or under the belt.....

Yesterday I reworked my CAT and got the idea to change the position of the servo from the right to the left side. sure, this requires a change of the part 3557 and 3558, too. The belt is mounted high enough, so that the servo would fit under the belt..... I am using the alloy steering, so the wrong "way round" of part 3590 could be resolved ( I hope)
Did someone already made this change? Or how did you resolve the wiring? I have seen some pics here, but could not find the topic again....
I am not frigthened, if the left-right balance will be influenced. We are talking about a few grams, This could be cleared by using sone weight.

[bigred5765]

no need wires can be run neatly and tidily under belt lots of pics on posts on here
http://www.oople.com/forums/showthre...=62362&page=15

[bigred5765]

and here
http://www.oople.com/forums/showthre...ghlight=wiring