X2c Steering probs

[Lee24h]

hi having problems with the steering assembly on my x2c its very lose however built correctly and all the screws are tight
also i do not have much full lock compared to some other x2c's that i have compared to and nothing compared to a schumacher sv2

[luniemiester]

Do you have servo saver fully wound up and locked up and are you running the ansmann servo horns?

[welshmerlin]

Lee, have you tried changing your steering rate on your controller? (if you can) It changes how much full lock you get.

Steven B

[Lee24h]

yes the servo saver is quite tight and the rest is standard ansmann
steven i have done all that i just cant get any more lock

[PaulUpton]

Lee screw the servo saver all the way tight with spring fully compressed and glue the nut into place. Also the 2 plastic peices that interlock glue them together as well

[welshmerlin]

Paul spotted Steven's car didn't have full lock a few weeks ago. Controller was set to 100 percent which we thought was maximum. We discovered we could go past 100 and ended up at 140 ish for full lock.

Mike

[PaulUpton]

Originally Posted by welshmerlin

Paul spotted Steven's car didn't have full lock a few weeks ago. Controller was set to 100 percent which we thought was maximum. We discovered we could go past 100 and ended up at 140 ish for full lock.

Mike

Yeh make sure full lock is on. But glue up the lot too

[Lee24h]

Thanks to everyone who posted it may be sorted now took the spring out the servo saver and reset the trim and adjusted the turnbuckles acording it looks better so it should be much better on tuesday

[Smartalec]

Bring it over to me on Tuesday Lee and I'll take a look

[Lee24h]

cheers alec