Quote:
Originally Posted by markwilliamson2001
Just thought I would post up on here, yes it was for a B4, and the pack fitted in without modifications, although you may need to redo your battery wires, as the connections for the battery are at one end of it.
It was running at 3.00A when it hit 8.4 volts then reduced to less than 1.0A pretty quickly. After this the voltage on the charger seemed to suddenly go up to 9.0v so I am unsure of what I did wrong..(apart from buy the balancer).
I was only going to use it this time without the balancer, as I could afford one this month! Damn
|
Quote:
Originally Posted by markwilliamson2001
|
Mark have to say either your charger was faulty or not set to lipo mode
amps should be allot lower when 8.4 volt is seem as in well under 1 amp on the display, i have a robitronics and its works ok.
the balancer is not a necesity but it is a safer way due to the added saftey features of the fact it will not allow over charge or undercharge.
be intersting to see the result of your charger test from the manufatcures.
even so, good on Trakpower leaders in technology and leaders in customer support!
treat yourself to a balancer
