The ID of the hb losi hex is smaller than the diameter of the sp front axles. The drive pin is also larger. What I did to make it work was a bit extreme. I took down the diamater of the axle (a spare set just incase things went bad) at the pin location so the hex would fit up on it. I then made the area the pin fits into the hex larger. There are probably better ways but this is the best one so far. If you could get someone to machine a set of hexes the size of a streetweapon hex with the proper id, and slot for the larger pin, that would be perfect lol. If you do this, I would also recommend using a non-flange wheel nut. It seemed to keep the wheels on better.
As for the rear, you will need the kyosho proline rear axles. They go for about 21-24 usd and can be found at amainhobbies and speedtech.
|