Quote:
Originally Posted by Zoea
Since on the durango the balls and holes for the hinge ends are very rounded I will see how the thread goes, and maybe take you up on this later. It's certainly cheaper  Don't get those screw drivers out just yet, thanks. |
No need to get the screwdrivers out, and I was curious anyway. I tried to fit one of those plastic 4mm spacers into the "rear suspension hanger" (part 330344). The plastic spacer is just a fraction too big. Less than a minute with a needle file to chamfer one side, and I managed to get it to fit. The hinge pin is not as snug in there as with the original part (you can see the gap in one of the photos below), but it would be fine to use in an emergency.
http://www.wannarace.co.uk/temp/photos/Durango01.jpg
http://www.wannarace.co.uk/temp/photos/Durango02.jpg