So had the Original RPM gearbox complete come today.....
After some research on this gearbox, its apparent that the RPM box was made for the RC10T and also fitted to the standard rear end RC10s.
It was not made to fit in the narrow rear ended RC10 worlds/RPM ULTRA MOLD without very slight modification.
So again, after research for what modification had to be done, I found 2 modifications.
1. Dremel the complete lower side around the hinge pin/toe block of each side of the case.
2. Dremel/cut the hinge pin holder/toe block and a very slight Dremel on each corner of the case both sides.
So after some thought, I went for the 2nd of the two.
I trimmed with a very TWITCHY BUMHOLE the hinge pin holders and the corners of the case. It has taken me best part of 4hrs to complete this as the price of the RPM gearbox and none in the whole world of RPM parts the rear hangers did I want to mess this up.
But its complete and fits like a glove YEAH BABY !!! Relief......
I will post pics tomorrow of this complete and the small 4hr mods I did.....
