Quote:
Originally Posted by Dadio
After a lot of trawling I found where i read that RC10 dog bones would fit up front on the dogfighter ,it was on OLD ONES AND FIRST ONES forum ,what is said there is that the pin to pin length is exactly the same but the pins and balls might need modifying ,this makes sense with the metric/imperial issue ,so that got me thinking ,should i modify the shafts that are common and easy to find or modify the cups to fit the shafts ? or i guess go the long way round and make up new axles and out drives on my lath to fit the drive shafts and keep the original parts as spares ,not too sure my lath tools would be up to hardened steel though so they would be mild steel and even if I case hardened them they would still wear badly ...............
|
Check you inbox. I have you covered