RC10 Worlds re release CVD issue
Hi All,
During the build of my Rc10 Worlds re release car, I have found one of the CVD drive shafts does not move/rotate smoothly once ensuring the pin is fully through the CVA axle. It's as almost as if the CVA axle has not been drilled correctly and is slightly off set.
Anyone else seen this, any fix or is this a new CVA axle?
I also found the transmission ruff as nails - although I have read it will bed in after a first run.
Cheers
Simon
__________________
Xray XB4 2015, 2016, Xray XB2, RC10 Worlds Re-release
|