Quote:
Originally Posted by westyguesty
had mine for a few months, and got half a problem with it. One of the channels works fine, the other charges one of the cells (2s 7.4 lipo) quickly as it should, the other cell can take an hour longer to balance back up.
Swapped leads, lipos etc between the two channels and no difference.
I think it's a problem with particular unit, and no-one else has reported similar. Other than that its a great bit of kit.
|
if you look at the spec below it says that one channel is 200w and the other is 100w = CH A 0.1-20A / CH B 0.1-10A ore do i misunderstand it?:
Feature:
•Large Screen LCD (128*64)
•Terminal Voltage Control
•Re-peak Mode for NiMH/ NiCd Battery
•Battery Meter
•Battery Internal Resistance Meter
•Soldering Iron: 60W MAX, 200-450 C
•PC Communications: USB Port for PC Control & Firmware Upgrade
•Smart Phone Control & Monitor Via Wifi Module (SK-600075 Optional Part)
•Two channels charge two different kinds of batteries simultaneously
•Support charging power distribution when operating with AC input
Specification:
•Input Voltage: AC100-240V/ DC 11-20V
•
Charge circuit power: DC Input CH A 200W/ CH B 100W / AC Input 200W (Support Power Distribution)
•Discharge circuit power: 10W x2
•
Charge current range: CH A 0.1-20A / CH B 0.1-10A
•Discharge current range: 0.1-5.0A
•Current drain for balancing port: Max 300mA/cell
•Ticket Charging Current: 30mA-300mA & Off
•LiPo/LiFe/Lilon cell count: 1-6Cells
•NiCd/NiMH battery cell count: 1-15Cells
•Pb battery voltage: 2-20V
•Dimension: 197x182x71mm
•Net weight: 1260g
Include:
•SKYRC D200 Charger (1 pc)
•XH Adaptor (2 pcs)
•Power Cord
•Charging Cable (1 pcs)
•Banana Connectors w/ XT60 Connector Charging Cable (2 pcs)
•Soldering Iron Handle
•Soldering Tip (Pencil Tip)
•Soldering Tip (Chisel Tip)
•Soldering Iron Stand
•Cleaning Sponge