Quote:
Originally Posted by Welshy40
Very very nice
Ok after doing an event this weekend, found the perfect carpet set up. Size one all round pistons, 30wt front oil with black springs, 35wt rear oil with silver springs. 25 degree castor blocks. Tie rod ball joint Inner hole on front shock tower and rear tower. middle hole on front tower if using three hole for top of shock, and middle / inner on rear (basically i prefer front & rear shocks angled identically. Rear wishbones, middle hole (if using 3 hole wishbones, otherwise outer if 2 holes). Front wishbone outer hole. Battery saddle pack forward placement with foam insers by rear tower. 10g weight on either side of full size servo (used for more weight). Vts slipper clutch fitted with ceramic diff balls and tungsten thrust race. Rear hubs set on middle. 2wd slim yellow mini pins and uncut, rear yellow mini pins uncut. Ride height rear with 1mm spring spacer and no spring clamp. Front with spring clamp and 4mm spacer. Shocks worked better with 1mm pack so gets hard to push shaft fully into body 1mm from end of travel, with standard silver shock shafts as gold is a lot harder to get pack.
Hope this helps
|
Thanks Welshy for sharing, this will be helpful
