Ok, hoping i get a reply but have emailed someone regarding a 3d drawing of the ZX knuckle arm, Im after the inner two holes where the end of the kingpins reach to be countersunk as ive a simple resolution to ever losing king pins again, plus getting fed up that this is one of the most problematic item ive had and cost me numerous A finals. Plan is to use a countersunk screw just long enough to get in via the bearing hole section and have enough thread to get attached to via a lock nut which is going to be attached on the castor block side. Once ive a 3d version made up im going to try and get a few pairs made up in alloy or plastic.
Once done just got to sort out my gearbox issues.
|