[Adam Skelding]

Originally Posted by Ryantothec

Alot of the holes did not line upon a few of the main chassis parts...
i think i'll try 35 in the front... I'm considering going over to B44 shocks and axles all around......

Tight indoor, high traction, moist is what im running on... with losi pink tapers all round... with kit springs...
The time that it was running it struggled steering comparing it to a basic setup B44... and the rear seemed to want to come out when on power steering ... either no steering or too much it seemed... however i had the rear sway off. how much is the front one-way doing for everyone?

If you could send pics of these holes that don't line up that would be good. We've had zero complaints about the kit build up in the area you are suggesting.

As for drive pins, I've never had a problem with them and I don't file a slot.. Good threadlock is the key here. Loctite 242 is my favorite flavour... It holds, but you can still get them out if need be.

If your on Taper Pins, try my set up from Hot Rod Hobbies. It's on the HB website under D4 > setups.