Thread: Kf bulkhead
View Single Post
  #4  
Old 28-09-2015
Stevebolt's Avatar
Stevebolt Stevebolt is offline
Member
 
Join Date: Jan 2014
Posts: 158
Default

Quote:
Originally Posted by andy-aj View Post
Pilot drill, 2.5mm, though the hole and out other side at the same angle as the hole in the bulkhead. Then screw in a M3 20-25mm set screw until there is only 10mm sticking out the front. Push the tower and shock guard on, and secure with a couple of washers and nyloc nuts.
Could you point me in the direction of the set screw please.
Reply With Quote