Quote:
Originally Posted by Ryantothec
I built mine this week and raced last night... I had nothing but problems with mine... This kit overall to build was somewhat of a pain... I've been racing over eight years and im a sponssored driver (not by hot bodies)....
What is everyone doing about the constant drive shaft pins backing out and falling off?
and
I don't know where to go as far as setup, it needs alot more steering in general, and feels nowhere as good as a B44... I'm running on a high traction tight indoor 40wt in front and 30wt in rear...
|
My opinion is the toatl opposite
The kit was a joy to build, no problems at all.
I did grind flats onto the driveshaft pins for the grub scews to tighten onto, but I do that on any car. I also put heat shrink round the joint once done.
Set-up wise, IMHO the car has heaps of steering.
What surface are you running on, and what is your full set-up? Maybe we can help.
G