here is the photos of my car
the build was good few bits I'm not sure of like the thread on the shock shafts being minimal and the nut might un-wind and moulded pistons.
on the photo of the screws shows the only issues I had with the build
1 rear shock tower to shock screw was 3mm to short
and 1 front top link ball stud was 15.25 and should of been 17.5 I think
quick call to tony at serpent and they was in the post the same day!!
also bought a set of machined pistons
anyone wanting to build this car will need a 4.5mm nut driver witch was kinda frustrating
ive not had my lipos yet so the battery wires are long but apart from that its good to go
