Quote:
Originally Posted by draperst
Hi Mark, how did you get your esc so close to your servo? I tried it but the wires run out of the left hand side, would appreciate your insight. Also what lipo connectors are they? Thanks! Stuart
|
I did the same without taking a solder to the servo.
Take the baseplate off, slide the rubber grommet along the servo wire and then carefully remove a small amount of plastic from the baseplate so the wire can exit straight back from the servo. Screw the baseplate back on and then fold the wire along the bottom of the baseplate, holding it in place with some Shoe-Goo.
If you ever want to sell the servo, the grommet will go back and the wire can be restored to the original position.
Note that when you do this you will break the paper seal on the servo and your warranty will be void. HTH
