Well I did exactly that and still the same orange colour LED and no setup.
I have looked at the soldering and its not the best but is all in tact.
What I don't understand is that when 'switch it on', this means plugging in the battery as there is no switch. So when i plug the esc into the battery i have my finger on the on/setup button, which from reading the instructions and also is pretty standard way of calibrating most escs. But it does not go into the setup mode.
The issues are
Orange LED always on (signalling sensorless)
RX LED not on (but maybe it has to be calibrated first)
The Fan going
So the esc is getting power, but wont go into setup mode. Is it likely to be poor soldering. I may take a photo and upload.
Thanks
|