Thread: Yokomo YZ-2
View Single Post
  #583  
Old 08-07-2015
Allan1875 Allan1875 is offline
Senior Member
 
Join Date: Nov 2010
Location: Scotland
Posts: 609
Default

Quote:
Originally Posted by discostu View Post
It's pretty simple moving the inside link closer to the rear of the car calms the steering feel Down
Adding 4mm washers on the Yz2 is moving it closer to the front of the car and this is what calms it down.

The angles don't lie.

Quote:
Originally Posted by discostu View Post
It won't make any difference on a 2wd 4wd revers bel crank slider rack Ackerman is Ackerman the further the link is back in the centre the less aggressive feel You will get the further forward the more aggressive feel especially around the mid corner of a corner.
We are going to have to disagree on this as per above.

Quote:
Originally Posted by timoxx4 View Post
What did you use to measure it ? I would like to have a go at that myself on other cars just to see whats what.
It was an extremely technical measurement. Stuck the car on an A4 piece of paper on full lock (make sure the car is square with the paper). Draw a line along the edge of the wheel to get the angle it is facing. Once you lift the car off, draw another line square with the paper to meet the line you have already drawn then measure your angle with a protractor.

Highly technical stuff, I know. Ha. Obviously my figures are not going to be exact but it gives you an idea of where you are at.
__________________
Ardgay Models
Schumacher
CORE-RC
Hobbywing
Mark One Designs

Last edited by Allan1875; 08-07-2015 at 07:40 AM.
Reply With Quote