just set the third one of mine up, are you sure you are pressing the setup button down? use a 1.5 mm hex driver as they are fiddly. As you can move the servo I am presuming you have bound the receiver to it ?
what tranny and receiver you using, I am sure someone had problems with a futaba with these ESC.
I did find the instructions on the web somewhere, but the hobbyking one does the trick. This is what I did
switch tranny on
press and hold set up button with 1.5mm hex driver
switch on ESC, hold set up until yellow light comes on (few seconds)
Leave tranny in neutral position yellow light is on, press set up button, light changes colour to red, pull full throttle, press set up button again, light changes to green, apply full brakes , press set up button again, then lights go back to yellow.
Your done, switch of ESC to save settings
hope you can get it sorted as I find these to be great ESC and have never let me down once, that's why I have them in three separate cars.
cheers Steve
|