It is an LRP Flow,
Lights come on, and it looks like you can go through the set up process. The manual says to hold the 'set' button for 3 seconds to enter set up mode. This however does not seem to happen, although you can hold the 'mode' button for 3 seconds to enter what looks to go through a series of selections.
I don't have a PT so can't check that.
I will suspect that the ESC isn't set up correctly, I will have a sit down with the manual, but like you say it does not look like the receiver is getting any power which would also explain why the servo is inactive.
I am not used to modern Esc's but I would have expected without going through the set up process that it would still send power to the receiver?
Thanks for the help so far
|