Quote:
Originally Posted by jpmatrix
I have swapped over to the rb6 arms but haven't drilled the 3rd hole yet.
I see most of you guys have drilled out the 3rd hole. Is it necessary to drill it out?
From looking at it, drilling the hole slightly further in on the arm would result in more droop and would make the rear end softer?
James
|
James...
Yes Defo worth drilling.... From memory I think it's 17.8mm from the anti roll bar mount hole..or just buy UM713B... With these arms on and using the new hole use the medium shock ends.
Incidentally the oils are wrong on the set up sheet it should be 40wt front and 35wt rear.
I've used these arms with new hole on the RB6 in conjunction with the front brass suspension holder and the new rear front brass (RF) hinge pin holder...cars really good too
