Thanks man!
I guess you could say I am going for a re-engineer of the CAT, trying to keep the parts looking as stock as possible but using updated materials in some areas with some small strengthening work, this car is going to be used on astro so want it to be strong, and have replacement parts when I do break something....
I have some 2mm 7075 aluminium for the side plates so slightly thicker than stock but should be a whole lot stronger, still tossing up what material to use for the layshaft bearing holders, either alloy or carbon(cut or molded), gearbox plates will be bare alloy with black(or maybe polished) caphead screws for fixings.
Have you tried using any of the different positions for the lipo?
__________________
Slavich Design
Last edited by fathead; 27-04-2015 at 10:51 AM.
|