Hi - I hope no-one minds me bumping this old thread..
I love my b4s, I have 2 with electrics and one almost roller. They are all rc10b4.0 buggies
I am running a couple of 6000mah Intellect (ip) 2s lipos in one of them. The problem I see is the battery thickness means that when I use them with the factory team thumbscrews, I can't tighten the thumbscrews down. They are loose and so far I've lost 2 (of 4 I think). What would be the way to get them to tighten at a larger height, could I just undo the screw cups they tighten into a bit?
By the way, the factory team bar won't fit in it's proper place, I've just been running it above that on the shock tower (So it's only the bar's tension and the 2 blue FT thumb screws holding it in place - but then it's already in a cut out chassis hole)
I see quite a few posts about people even running 3s in theirs, if you managed to fix a tall battery in your B4 and are not loosing thumbscrews "bashing" as I am, I would love to know a fix. I have velcro and a dremel handy
Thanks Everyone
|