Quote:
Originally Posted by neallewis
Tidy! But you need to shorten those servo leads ;-)
Where did you pass the receiver wire to get it into the mount?
I think Yokomo designers missed a trick here. Antenna mount should be on both sides IMO.
|
Haha I am going to shorten them but I don't have the tool to do the shortening properly. I shortened my transponder lead by just cutting and soldering the wires again as it was wayyyy too long also.
My receiver wire runs along the battery foam for a few mm, then runs down the middle of the esc and the receiver, then round the back between the esc and servo. The idea was to keep the antenna as short as possible as I hate them.
