[Cliveyp]

Any advice on a carpet setup guys?

I've had mine on a kit setup for a while, and it has been running OK on yellow low-profile cut staggers on the front with yellow mini spikes on the back. After being assured that mini pins on the rear would actually be better, I changed them but then struggled for front end grip.

The surface was indoor, multi type carpet with some wood. Generally flat with some low jumps/ramps/rollers. Changes from kit setup now I'm running the pins are;
- longest front links
- 40wt oil in front shocks
- top outer damper mounts
- middle lower damper mounts

Found it turned in slightly better with the dampers back in the middle hole on the tower, but I ran out of heats to meddle. It was much more stable on the wooden parts with the outer top mounts.

Initial bite doesn't seem too bad, but then with either a tiny bit of throttle or whilst coasting, the mid to exit of the corner just washes wide. Any suggestions?