Quote:
Originally Posted by Toonz
the durga front and rear assembly universal and front and rear dogbones
are up on stella! woot!
|
Thanks for the advice!
I hope to see how the Durga goes this weekend. If I get dissapointed I'll but those CVDs right away
Quote:
Originally Posted by Sensory Overload
Note that I'm using the 5mm (under the rear pistons) spacers to correct droop on a carpet setup. 3mm in the front seem to level out the car. cvd's are near/slightly above level. Car feels good. So
|
I was planning to add the 3mm to the front also. However with only a 5mm spacer at the rear the front was slightly lower than the rear which should be a good thing right. If the handling isn't what I expect it to be, I'll add a 3mm to the front also. Thanks for the heads up!
Here's a picture of the car. The rear looks a bit high on the pictures as there are no electronics mounted in the car. However now with the motor installed it looks a lot better. I'll post another pic when finished
