you definitely don't run one with the 22 2.0, it comes with the metal hexes as standard, but it does have slightly different drive shafts. The washer has a small flange on it which sits on the inside of the bearing. and it also spaces the drive shaft a bit. The hex also has the same flange on it, so just try it and see.
You may find that the hex wont sit all the way down to the hub,because the pin holds it too far away, not sure as i didnt really play with the newer bits on the old car.
__________________
Tom
TLR 22-4 2.0, TLR 22 5.0 AC Elite,
Kindly Supported by Trackside Spares, TLR, Spektrum and Horizon Hobby
|