There was still an issue with using other make wheels regarding not much thread available on the rear stub axles.
I had some spare Team C CVD's of which the axles are slightly longer, so using the 222's dogbones & pin,
along with the Team C axle,
assembled but as the 222's pin is 11mm long (compared to the Team C's 10mm) & is held in place with a grub screw I haven't used the Team C securing ring, so looks like this,
Luckily I had these alloy 12mm hexes spare, these are 4mm wide (as against the 222's 3mm wide plastic ones),
and fitted,
Even with these I now have a little to spare unlike before,
