[fletcher]

its a bit much to write everything on a post but I predominantly run on carpet\wood mix (mostly carpet) so here goes (ill start with mods)
shorty setup
rear camber link mod
2wd rear hubs, driveshaft's
shock set up goes......
front - 6 hole 1.2 40wt black spring
rear - 6 hole 1.3 35wt red spring
outer hole on bottom of rear wishbone and 3rd. Hole in on tower.
outer hole on front wishbone, mid hole on tower.
1 degree camber all round
rear hub spacing 5mm in front and 1mm behind
10g of weight on front belt tunnel
10 degree castor
thin front roll bar
3 degree lrc rear block with 2.5 anti squat (hrc block may be better)
rear shock mod (wishbones swapped with shicks on front of tower.

anything else just ask