Well i've started work on the chassis. The first job I decided to do was wrap the chassis, just to give it a little bit of extra protection (see attached photos) It took a bit of work to design and cut, but it came out nice for the top and underside of the chassis.
I have also thought up with a few possible solutions for the front and rear droop - washers/spacers underneath the front suspension arm/rear suspension cage that will raise the arm/cage slight, or for the rear at least, using the other rear suspension mounts, using a pair of csk screws, riv nuts and spacers, hopefully just enough to achieve the desired effect and limit droop. Any thoughts on this?
|