Quote:
Originally Posted by neallewis
Sure I'll try do one later.
Yeah the spur noise has been covered earlier on this yea in the main Bmax4III thread. There is a bit of bearing slop in the slipper motor pod. With the top plate off, place some squares of tape on either the top of the bearing edge, or on the underside of the top plate where is will make contact with the slipper bearings. This packs out the bearings in the mounts and stops the movement and noise.
I noticed the newer centre mount (B4-304C2) that comes with the lightweight chassis is a much better fit around the bearing.
|
Hi Neal, did you manage to get a picture of the kf protector fitted to your bmax4?