Quote:
Originally Posted by jimmy
hmmmmmm, where are you getting all that steering from? The DF03 shocks aren't the best, but perhaps I'd look at tuning those before anything else since it's the only majoy handling thing you've changed from the kit setup - which I raced twice and didn't find the same (oversteer)?
the steering wasn't terrible but I really wanted a one-way to get the car to turn enough.
Maybe try going to a harder oil / piston / spring in the front? The supplied df03 hopup shock pistons aren't ideal - I ended up putting in 501X shafts so I could use 501X pistons, which was a load better (this was on a DF03).
Shame you have to use Tamiya tyres but they aren't too bad. You'd probably easily put in another lap or two just by going to schumacher tyres.
|
Thanks Jimmy (great site by the way!) Funny think is that I'm running 50wt/DF03 2 hole piston w/gold springs in the front followed by 40wt/Df03 2 hole using the std gun metal spring from the DF03 kit. Should I still go higher??? Not using a oneway - yet. I'm also using the 501x alloy uprights to fine tune roll center and arm lenght. Will the losi or associated springs work?? what about trimming the outer edges of the front tires. the TCS Tamiya rolls may allow it.